Hyundai Accent Manuals

Hyundai Accent: Removal - Brake Line. Repair procedures - Brake System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Line. Repair procedures / Removal

1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Loosening the tube flare nut (B).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
[Front]

[Rear]
5.
Disconnect the brake tube by remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).
Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
[Front disc brake]

[Rear Disc brake]

Brake Line. Repair procedures
...

Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Installation
• Install the component with the specified torques. • ...

Recommended lubricants and capacities
To help achieve proper engine and powertrain performance and durability, use only lubricants of the proper quality. The correct lubricants also help promote engine efficiency that results in impro ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired positio ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com