1. |
Disconnect the stop lamp switch connector (A).
|
2. |
Adjust the brake pedal height (A) as illustration below.
|
3. |
Adjust the stop lamp switch clearance (B) and brake pedal free
play.
|
4. |
Connect the stop lamp switch connector.
|
1. |
Disconnect the stop lamp switch connector (A).
|
2. |
Pull the locking plate (A) as indicated by the arrow.
|
3. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
4. |
Fix the brake pedal arm and insert fully the stop lamp switch
as hiding contact part.
|
5. |
After inserting, turn the stop switch (A) 45° clockwise, and then
assemble locking plate (B) by pushing.
|
6. |
Confirm the gap between stop lamp switch and bracket.
|
7. |
Connect the stop lamp switch connector.
|
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation. Your Hyundai deale ...
Rear Body ( 5Door )
Side outer panel rear corner
Tail gate hinge mounting hole (Ø14)
Tail gate hinge mounting hole ...
Power Out Side Mirror Switch. Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front d ...