Hyundai Accent Manuals

Hyundai Accent: Removal - ESC Control Module. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Removal

1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the connector.

3.
Remove the brake fluid from the master cylinder reservoir with a syringe.
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
4.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.

Tightening torque:
M11: 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
M14: 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

•
Never attempt to disassemble the HECU.
•
The HECU must be transported and stored in.
•
Never shock to the HECU.
6.
Remove the 3 bolts, and then remove the bracket from HECU.

Tightening torque:
11 ~ 14 N.m (1.1 ~ 1.4 kgf.m, 8.1 ~ 10.3 lb-ft)


ESC Control Module. Repair procedures
...

Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

Components Operations
PCM (Power Train Control Module) 1. The PCM (ECM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transp ...

Schematic Diagrams
Circuit Diagram ...

Power Window Motor. Repair procedures
Inspection Front Power Window Motor Inspection 1. Remove the front door trim panel. (Refer to the BD group - "Front door") 2. ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com