Hyundai Accent: Replacement
Tail Gate Trim Replacement
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Put on gloves to protect your hands.
|
|
1. |
After loosening the mounting screws, then remove the tail gate
trim (A).
|
2. |
Installation is the reverse of removal
• |
Replace any damaged clips.
|
|

|
Tail Gate Latch Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the tail gate latch rods (A).

|
3. |
After loosening the mounting bolts, then remove the latch assembly
(A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
|

|
4. |
Disconnect the tail gate latch connector (A).

|
5. |
Installation is the reverse of removal
• |
Make sure the connector is connected properly
and the connecting rod is connected properly.
|
• |
Make sure the tail gate opens properly and locks
securely.
|
|
|
Key Holder Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the key holder rod (A), then loosen the key holder
(B) mounting bolts and remove.

|
3. |
Installation is the reverse of removal
|
Outside Handle Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the outside handle rod (A).

|
3. |
After loosening the mounting nuts, then remove the outside handle
(A).

|
4. |
Installation is the reverse of removal
|
Tail Gate Lift Replacement
•
|
Take care not to be closed the tail gate, when removing
the lift.
|
|
1. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the lifter from the bracket
(C).

|
2. |
Push the socket of the lifter into the bracket for installation.
• |
Make sure the tail gate lock and opens properly
and locks securely.
|
|
|
Tail Gate weatherstrip Replacement
•
|
Do not apply sealant to the body.
|
|
1. |
Remove the tail gate weatherstrip (A).

|
2. |
Installation is the reverse of removal.
• |
Install the weatherstrip aligned with center line
(B).
|
|
|
1.
After loosening the tail gate hinge (A) mounting bolt, adjust
the tail gate by moving it up or down, or right or left.
2.
Adjust the tai ...
See also:
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the lower anchor bolt.
...
Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The sys ...
Removal
•
Take care not to scratch the center fascia panel and related
parts.
...