Replacement
1. |
Remove the wiper arm cap (B) and remove the nuts, then remove
wiper arm (A).
|
2. |
Remove the washer hose (B).
|
3. |
Detach the clips, then remove the cowl top cover (A).
|
4. |
Installation is the reverse of removal.
|
Winter driving
More severe weather conditions of winter result in greater wear and other problems.
To minimize winter driving problem, you should follow these suggestions. ...
Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
se ...