Hyundai Accent: Inspection
Driver Door Lock Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
...
See also:
If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the LOCK position, check all connectors at ignition
coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the engine sti ...
Reassembly
1.
After spreading grease on the rack bar gear part (A), install
rack bar (B) in the direction of the arrow.
...
Fuse Inspection
1.
Be sure there is no play in the fuse holders, and that the fuses
are held securely.
2.
Are the fuse capacities for each circuit correct? ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com