Hyundai Accent: Removal
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 3. |
Disconnect the power window switch module connector (A) from the
wiring harness.
|
| 4. |
Remove the power window switch module (A) from the door trim after
loosening the mounting screws (5EA).
|
Inspection
Driver Door Lock Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to ...
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...
See also:
Remote keyless entry
Remote keyless entry system operations
Lock (1)
All doors are locked if the lock button is pressed. If all doors, trunk and hood
are closed, the hazard warning lights will blink once to indicate ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
If you have a flat tire (with tire mobility kit)
For safe operation, carefully read and follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tire Mobility Kit is a temporary fix to the tire and the tire sho ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com