Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
| 3. |
Disconnect the connector. Release the lock of wiper switch using
tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch ...
Installation
1.
Install the wiper switch.
2.
Install the steering column upper and lower shrouds.
...
See also:
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Purge Control Solenoid
Valve (PCSV). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Relay Box (Passenger Compartment). Components and Components Location
Components
...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com