Hyundai Accent: Inspection
| 1. |
Check that the light operate according to the following timing
chart.
|
| 2. |
If the daytime running light is not operated well, inspect the
connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary,
and recheck the system.
If the terminals look OK, go to step 3.
|
| 3. |
Make these input tests at the connector
If any test indicates a problem, find and by using ETM correct
the cause, then recheck the system.
If all the input tests prove OK, the junction box must be faulty;
replace it.
|
Installation
1.
Install the DRL unit.
2.
Install the glove box.
...
Lighting System
...
See also:
Crankshaft Position Sensor
(CKPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable ...
Installation
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com