Hyundai Accent: Installation

Removal

1. Disconnect the negative (-) battery terminal. 2. Disconnect the fog lamp connector (A). 3. Remove t ...

Inspection

Multifunction Switch (Lighting) 1. Disconnect the negative (-) battery terminal. 2. Remove the lighting switch of the multi-function switc ...

See also:

To decrease the cruising speed
Follow either of these procedures: Push the SET- switch and hold it. Your vehicle will gradually slow down. Release the switch at the speed you want to maintain. Push the SET- switch and re ...

Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...