Hyundai Accent: Battery recharging
Your vehicle has a maintenance-free, calcium-based battery.
If the battery becomes discharged in a short time (because, for example the headlights
or interior lights were left on while vehicle was not in use) jump start the vehicle
from another battery and run the engine at least 20 minutes at idle before driving.
Do not turn off the engine for 30 minutes total of idle and/or driving as the battery
may not have sufficient recharge to start.
WARNING - Recharging battery
When recharging the battery, observe the following precautions:
- The battery must be removed from the vehicle and placed in an area
with good ventilation.
- Do not allow cigarettes, sparks, or flame near the battery.
- Watch the battery during charging, and stop or reduce the charging
rate if the battery cells begin gassing (boiling) violently or if the temperature
of the electrolyte of any cell exceeds 120°F (49°C).
- Wear eye protection when checking the battery during charging.
- Disconnect the battery charger in the following order.
1. Turn off the battery charger main switch.
2. Unhook the negative clamp from the negative battery terminal.
3. Unhook the positive clamp from the positive battery terminal.
WARNING
- Before performing maintenance or recharging the battery, turn off
all accessories and stop the engine.
- The negative battery cable must be removed first and installed last
when the battery is disconnected.
- Operation related to the battery should be done in an authorized HYUNDAI
dealer.
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spil ...
Items should be reset after the battery has been discharged or the battery has
been disconnected.
Auto up/down window (See section 4)
Sunroof (See section 4)
Trip computer (See section 4)
...
See also:
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Parki ...
Circuit Diagram (2)
...