Hyundai Accent: General Service Information
Hyundai Accent RB (2010-2018) Service Manual / General Information / General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before
starting work.
The support rod must be inserted into the hole near
the edge of the hood whenever you inspect the engine compartment to
prevent the hood from falling and causing possible injury.
Make sure that the support rod has been released
prior to closing the hood. Always check to be sure the hood is firmly
latched before driving the vehicle.
|
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment
are available starting work.
Meaning Of Symbols
There are five primary symbols used to complement illustrations.
These symbols indicate the part to apply such materials during service.
Symbol
Meaning
...
Special Tools
Use special tools when they are required.
...
See also:
Removal
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Turn the steering wheel so that the ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Main components of occupant detection system
A detection device located within the front passenger seat.
Electronic system to determine whether the front passenger air bag system
should be activated or deactivated.
A warning light loca ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com