1. |
Inspection of parts
Each part, when removed, should be carefully on suspected
for malfunction, deformation, damage, and other problems.
|
2. |
Arrangement of parts
All disassembled parts should be carefully arranged
for effective reassembly.
Be sure to separate and correctly identify the parts
to be replaced from those that will be used again.
|
3. |
Cleaning parts for reuse
All parts to be used again should be carefully and
thoroughly cleaned by an appropriate method.
|
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...
Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant
Coding” procedure.
1.
On ...
Electric power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the
engine is off or if the power steering system becomes inoperative, the vehicle may
still be steered, but it will requi ...