Hyundai Accent Manuals

Hyundai Accent: Exhaust Manifold. Repair 
procedures - Intake And Exhaust System - Engine Mechanical SystemHyundai Accent: Exhaust Manifold. Repair procedures

Removal and Installation

1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.

Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)

3.
Disconnect the front and rear oxygen sensor connectors (A).

4.
Remove the front muffler (A).

Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

5.
Remove the exhaust manifold stay (A).

Tightening torque:
39.2 ~ 49.0N.m (4.0 ~ 5.0kgf.m, 28.9 ~ 36.2lb-ft)

6.
Remove the heat protector (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Remove the exhaust manifold (A).

Tightening torque:
29.4 ~ 41.2N.m (3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft)

When installing, replace with a new gasket.
When installing the intake manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.

8.
Installation is reverse order of removal.

Exhaust Manifold. Components and Components Location
Components 1. Heat protector 2. Exhaust manifold 4. Exhaust manifold gasket 5. Exhaust manifold stay ...

Muffler. Components and Components Location
Components 1. Front muffler 2. Catalytic converter & center muffler assembly 3. Main muffler 4. Gasket 5. Hanger ...

See also:

Installation
1. Install the washer reservoir. Before installing the pump motor, check the f ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Disassembly
Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. M/T : Remove the fly wheel. 2. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com