Hyundai Accent: Description and Operation
Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Starting System / Description and Operation
Description
The starting system includes the battery, starter, solenoid
switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection
wires and the battery cable.
When the ignition key is turned to the start position, current
flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated,
and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks. In order
to prevent damage caused by excessive rotation of the starter armature when
the engine starts, the clutch pinion gear overruns.
|
1. Solenoid 2. Brush 3. Armature 4. Overrun clutch |
Starting System
...
Repair procedures
Troubleshooting
Starter Circuit
The battery must be in good condition and fully charged.
1.
...
See also:
Rear Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Refer to the BD group - " Trunk Lid")
...
Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely
hazardous. Always leave the vehicle in gear.
Do not "ride" the brakes. This can cause them to overheat and ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com