Hyundai Accent: Starter Relay. Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Starting System / Starter Relay. Repair procedures
Inspection
| 1. |
Remove the fuse box cover.
|
| 2. |
Remove the starter relay(A).
|
| 3. |
Using an ohmmeter, check that there is continuity
between each terminal.
|
| 4. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 5. |
If there is no continuity, replace the starter relay.
|
| 6. |
Install the starter relay.
|
| 7. |
Install the fuse box cover.
|
Cleaning
1.
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will
damage the insulation wipe these parts with a cloth only.
...
See also:
Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable (A).
3 ...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM (ECM)
or when providing additional keys to the vehicle owner.
Th ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com