1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Lift the vehicle.
|
3. |
Remove the fuel tank. (Refer to "Fuel Tank" in this
group.)
|
4. |
Disconnect the vapor tube quick-connector (A) and
the vapor hose (B).
|
5. |
Remove the canister assembly after removing installation
bolts (C).
|
Input Speed Sensor. Specifications
Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8)
0.0472 ...
Knock Sensor (KS). Description
and Operation
Description
Knocking is a phenomenon characterized by undesirable vibration
and noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knoc ...
Front Body A ( 4Door )
Hood hinge mounting hole (Ø10)
Fender apron upper member tooling
hole (Ø6.6)
Front shock ...