Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Repair procedures / Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.

Measure the output voltage of the RPS at idle and various engine speed.

Condition	Output Voltage (V)
Idle	Approx. 1.2
1,500 rpm	2.2 ~ 2.5
6,300 rpm	Approx. 3.0

Rail Pressure Sensor (RPS). Repair procedures

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to ...

See also:

Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Master Cylinder. Components and Components Location
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder assembly ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com