Hyundai Accent Manuals

Hyundai Accent: Installation - Purge Control Solenoid Valve (PCSV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Installation is reverse of removal.
Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector ...

CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

See also:

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace ...

Parking brake
Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone ...

Checking Cables And Wires
1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com