Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative
(-) battery cable.
|
| 2. |
Disconnect the accelerator position sensor connector
(A).
|
| 3. |
Remove the installation nuts (B), and then remove
the accelerator pedal module.
|
Installation
1.
Installation is reverse of removal.
Accelerator pedal
module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6
...
See also:
Tail lamp warning chime
If you turn the ignition switch to the OFF position with the tail lamps ON and
the driver's door in an open position, the warning chime will sound.
To stop the chime, perform one of the followi ...
Reassembly
1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
...
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com