1. |
Disconnect the back up lamp switch connector (A).
|
2. |
Remove the back up lamp switch (A).
|
3. |
Replace a new one and install the back up lamp switch.
|
Output Speed Sensor. Specifications
Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.85 ~ 1.3)
0.033 ...
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or
dipstick before checking or draining any lubricant. This is especially important
in dusty or sandy areas and when ...
Satellite radio reception
You may experience problems in receiving XMâ„¢ satellite radio signals in the following
situations.
If you are driving in a tunnel or a covered parking area.
If you are driving beneath the t ...