Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures / Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the oil temperature sensor connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures

...

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

See also:

Interior Trim. Repair procedures
Replacement Door Scuff Trim Replacement [Sedan] • Put on gloves to protect your ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to ...

Transmitter precautions
NOTICE The transmitter will not work if any of following occur: The ignition key is in ignition switch. You exceed the operating distance limit (about 90 feet [30 m]). The battery in the tra ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com