Hyundai Accent: Inspection
| 1. |
Check the driveshaft boots for damage and deterioration.
|
| 2. |
Check the driveshaft spline for wear or damage.
|
| 3. |
Check that there is no water or foreign material in the joint.
|
| 4. |
Check the spider assembly for roller rotation, wear or corrosion.
|
| 5. |
Check the groove inside the joint case for wear or corrosion.
|
| 6. |
Check the dynamic damper for damage or cracks.
|
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Disassembly
•
Do not disassemble the BJ assembly.
•
Speci ...
See also:
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
Components and Components Location
Component Location
1. Head lamp (Low / High)
2. Turn signal lamp
3. Front fog lamp
4. Position lamp
5. Turn signal lamp (Side repeater)
6. High mounted stop lamp
...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The ...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com