Hyundai Accent Manuals

Hyundai Accent: Removal - Passenger Airbag (PAB) Module. Repair procedures - Airbag Module - Restraint (Depowered)Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / Airbag Module / Passenger Airbag (PAB) Module. Repair procedures / Removal

1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolt (B).
4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Passenger Airbag (PAB) Module. Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

See also:

Installation
1. Installation is the reverse of removal. ...

Schematic Diagrams
Circuit Diagram ...

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com