Hyundai Accent: Adjustment

Hyundai Accent RB (2010-2018) Service Manual / Manual Transaxle System (M6CF1) / Manual Transaxle Control System / Shift Lever. Repair procedures / Adjustment

1.	Install the selected cable (B) to the selected lever (A) of the manual transaxle in engine room.

2.	Assemble the shift lever assembly (A) to the vehicle body.

3.

Install the following items;

(1)	Insert the selected cable (A) to the shift lever assembly pin(B).

(2)	Install the snap pin (C).

(3)	Be careful the shift lever not to move left or right side, push the lock piece (D) until sounds.

(4)	You have to push in the adjust (E).

(5)	Remove the neutral position pin (F).

Installation

1. Installation is the reverse of removal. ...

Back-up Lamp Switch. Description and Operation

Description Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

See also:

Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer. - Spraying washer ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Interior Trim. Components and Components Location
Components 1. Front pillar trim 2. Center pillar lower trim 3. Center pillar upper trim 4. Rear pillar trim [4 Door] 5. Rear wheelhousing trim 6. Front door scuf ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com