Hyundai Accent Manuals

Hyundai Accent: EBD(Electronic Brake-force 
Distribution). Description and Operation - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: EBD(Electronic Brake-force Distribution). Description and Operation

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / EBD(Electronic Brake-force Distribution). Description and Operation

Operation

The EBD system (Electronic Brake force Distribution) as a sub-system of the ABS system is to control the maximum braking effectiveness by the rear wheels.
It further utilizes the efficiency of highly developed ABS equipment by controlling the slip of the rear wheels in the partial braking range.
The brake force is moved even closer to the optimum and controlled electronically, thus dispensing with the need for the proportioning valve.
The proportioning valve, because of a mechanical device, has limitations to achieve an ideal brake force distribution to the rear wheels as well as to carry out the flexible brake force distribution proportioning to the vehicle load or weight increasing. And in the event of malfunctioning, driver cannot notice whether it fails or not.
EBD controlled by the ABS Control Module, calculates the slip ratio of each wheel at all times and controls the brake pressure of the rear wheels not to exceed that of the front wheels.
If the EBD fails, the EBD warning lamp (Parking brake lamp) lights up.
Advantages
-
Function improvement of the base-brake system.
-
Compensation for the different friction coefficients.
-
Elimination of the proportioning valve.
-
Failure recognition by the warning lamp.
Comparison between Proportioning Valve and EBD


Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed s ...

ESC Control Module. Components and Components Location
Components 1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ABS control module (HECU) 8. Damper ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer ...

Rear Seat. Repair procedures
Replacement Seat Assembly Replacement 1. After loosening the mounting bolt, then remove the rear seat cushion (A). Tightening torque : ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com