Hyundai Accent: Electrical System
Hyundai Accent RB (2010-2018) Service Manual / General Information / Electrical System
| 1. |
Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
|
| 2. |
Never pull on the wires when disconnecting connectors.
|
| 3. |
Locking connectors will click when the connector
is secure.
|
| 4. |
Handle sensors and relays carefully. Be careful not
to drop them against other parts.
|
Replacement
Standard values, such as torques and certain adjustments,
must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced
with new ones ...
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or
tubing.
...
See also:
26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams
Circuit Diagram
...
Wheel nut tightening torque
Steel wheel & aluminum alloy wheel:
65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly ...
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the d ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com