LOCK
The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the key inward at the ACC position and turn the key toward the LOCK position.
ACC (Accessory)
The steering wheel is unlocked (if equipped) and electrical accessories are operative.
NOTICE
If difficulty is experienced in turning the ignition switch to the ACC position, turn the key while turning the steering wheel right and left to release the tension.
ON
The warning lights can be checked before the engine is started. This is the normal running position after the engine is started.
To prevent discharge of the battery, do not leave ignition switch on for long time while engine is not running.
START
Turn the ignition switch to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position.The brake warning lamp can be checked in this position.
WARNING - Ignition switch
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The ...
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp fo ...
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...