Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Injector. Repair procedures / Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the injector connector.

3.	Measure resistance between the injector terminals 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Injector. Repair procedures

...

Removal

In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Refer to the BD group - " Trunk Lid") ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Installation
Front Speaker 1. Install the front speaker. 2. Install the front door trim. Rear Speaker 1. Install t ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com