Hyundai Accent: Inspection| Clutch Pedal Inspection |
| 1. |
Measure the clutch pedal height (from the face of
the pedal pad to the floor board) and the clutch pedal clevis pin play
(measured at the face of the pedal pad.)
|
| Ignition Lock Switch Inspection |
| 1. |
Disconnect 2P-connector from a ignition lock switch.
|
| 2. |
Disconnect the ignition lock switch. (if you can
install a tester with the switch fixed, this step can be omissible)
|
| 3. |
Check for continuity between terminals. (refer to
the table below)
|
RemovalSpecial Service Tools
Special Service Tools
Tool
(Number and name)
Illustration
Use
09200-38001,3N000 (Beam)
09200-2S100 (Adapter)
09200-2S200 (Supporter)
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Installation
1.
Install the fog lamp.
2.
Reconnect the fog lamp connector.
3.
Connect the negative (-) battery terminal.
...