Hyundai Accent: Installation
Door Mirror Turn Signal Lamp
| 1. |
Install the door mirror turn signal lamp to the door mirror.
|
| 2. |
Install the door mirror.
|
| 3. |
Connect the negative (-) battery terminal.
|
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...
Room Lamp. Repair procedures
Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications
Direct control VFS[UD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
ETC (Electronic Throttle
Control) System. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com