Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures / Installation

1.

Install the key lock cylinder.

When assembling, the key must be inserted at 'ACC' position.

2.	Install the key warning and immobilizer connector.

3.	Install the ignition switch.

4.	Install the steering column shrouds and crash pad lower panel.

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to the ST group - & ...

See also:

Power Window Switch. Repair procedures
Inspection Power Window Main Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, ...

Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. 2. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com