Hyundai Accent Manuals

Hyundai Accent: Installation - Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front bumper.
(Refer to the Body group - "Front bumper")
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
• Removal of the airbag must be performed according to the precautions/ procedures described ...

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

See also:

Speed sensing door lock system
All doors will be automatically locked after the vehicle speed exceeds 9 mph (15 km/h). And all doors will be automatically unlocked when you turn the engine off or when you remove the ignition ke ...

Adjustment
1. After loosening the trunk lid hinge (A) mounting bolts, adjust the trunk lid by moving it up or down, or right or left. 2. Adjust the tr ...

Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Tr ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com