Hyundai Accent Manuals

Hyundai Accent: Oil And Filter Replacement - Engine Oil. Repair procedures 
- Revised - Lubrication System - Engine Mechanical SystemHyundai Accent: Oil And Filter Replacement

•
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
•
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
•
In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.
1.
Drain the engine oil.
(1)
Remove the oil filler cap.
(2)
Remove the oil drain plug, and drain the oil into a container.
2.
Replace the oil filter.
(1)
Remove the oil filter.
(2)
Check and clean the oil filter installation surface.
(3)
Check the part number of the new oil filter is as same as old one.
(4)
Apply clean engine oil to the gasket of a new oil filter.
(5)
Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(6)
Tighten it with the torque below.

Tightening torque :
11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)

3.
Refill with engine oil.
(1)
Clean and install the oil drain plug with a new gasket.

Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)

(2)
Fill with fresh engine oil.

Capacity
Total : 3.7L (3.91US qt, 3.25lmp qt)
Oil pan : 3.0L (3.17US qt, 2.64lmp qt)
Drain and refill in cluding oil filter :
3.3 L (3.49US qt, 2.90lmp qt)

(3)
Install the oil filler cap.
4.
Start engine and check for oil leaks.
5.
Recheck the engine oil level.

Engine Oil. Repair procedures - Revised
...

Oil And Filter Replacement
• Prolonged and repeated contact with mineral oil will result in the removal of natural fats ...

See also:

Circuit Diagram (1)
Circuit Diagram (2) ...

Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Map lamp
Push the lens (1) to turn the map lamp on or off. This light produces a spot beam for convenient use as a map lamp at night or as a personal lamp for the driver and the front passenger. DOOR ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com