Hyundai Accent: Opening the fuel filler lid
The fuel filler lid must be opened from inside the vehicle by pulling the fuel filler lid opener switch.
NOTICE
If the fuel filler lid will not open because ice has formed around it, tap lightly or push on the lid to break the ice and release the lid. Do not pry on the lid. If necessary, spray around the lid with an approved de-icer fluid (do not use radiator anti-freeze) or move the vehicle to a warm place and allow the ice to melt.
1. Stop the engine.
2. To open the fuel filler lid, pull the fuel filler lid opener switch.
3. Pull the fuel filler lid (1) out to fully open.
4. To remove the cap, turn the fuel tank cap (2) counterclockwise.
5. Refuel as needed.
Fuel filler lid
...
Closing the fuel filler lid
1. To install the cap, turn it clockwise until it “click” one time. This indicates
that the cap is securely tightened.
2. Close the fuel filler lid and push it in lightly making sure that it is ...
See also:
Accelerator Position Sensor
(APS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the ...
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Hyundai Accent Manuals
