Hyundai Accent: Operating door locks from outside the vehicle

- Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
- If you lock the door with a key, all vehicle doors will lock automatically.
(if equipped)
- From the driver’s door, turn the key toward the rear of the vehicle once
to unlock the driver’s door and once more within 4 seconds to unlock all doors.
(if equipped)
- Doors can also be locked and unlocked with the transmitter.
- Once the doors are unlocked, they may be opened by pulling the door handle.
- When closing the door, push the door by hand. Make sure that the doors are
closed securely.
NOTICE
- In cold and wet climates, door locks and door mechanisms may not work
properly due to freezing conditions.
- If the door is locked/unlocked multiple times in rapid succession with
either the vehicle key or door lock switch, the system may stop operating temporarily
in order to protect the circuit and prevent damage to system components.
NOTICE - Unlock mode conversion (if equipped)
You can change the system to unlock all doors by turning the key to the right
once. If you want this feature (central door unlock mode), perform the following:
two stage unlock mode ↔ central door unlock mode
The unlock mode is changed alternately by pressing the lock button and unlock
button on the transmitter (if equipped) at the same time for 5 seconds or more.
The hazard warning lights will blink four times to indicate that the mode conversion
is completed.
WARNING
- If you don't close the door securely, the door may open again.
- Be careful that someone's body and hands are not trapped when closing the
door.

- To lock a door without the key, push the inside door lock button (1) or
central door lock switch (2) to the “Lock” position and close the door (3).
- If you lock the door with the central door lock switch (2), all vehicle
doors will lock automatically.
NOTICE
Always remove the ignition key, engage the parking brake, close all windows
and lock all doors when leaving your vehicle unattended.
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock bu ...
See also:
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder res ...
Components of the Tire Mobility Kit
0. Speed restriction label
1. Sealant bottle and label with speed restriction
2. Filling hose from sealant bottle to wheel
3. Connectors and cable for the power outlet direct connection
4. Holde ...
Installation
1.
Connect the cluster connector.
2.
Install the cluster assembly.
3.
Connect the trip switch connector.
...