Hyundai Accent Manuals

Hyundai Accent: Removal - Passenger Airbag (PAB) Module. Repair 
procedures - Airbag Module - Restraint (Advanced)Hyundai Accent: Removal

1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolt (B).

4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Passenger Airbag (PAB) Module. Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

See also:

SRS Control Module (SRSCM). Description and Operation
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that d ...

Fuel Filler Cap. Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com