Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor
connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove
the sensor from the surge tank.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and
IG ON.
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant
Coding” procedure.
1.
On ...
Interior H ( 5Door )
Seatbelt height adjust upper mounting hole (Ø15)
Seatbelt height adjust lower mounting hole (Ø15)
...
Starter Relay. Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay(A).
3.
Using an ohmmeter, check t ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com