Hyundai Accent Manuals

Hyundai Accent: Removal - Transaxle Oil Temperature Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor. Repair procedures / Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group)
2.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) )

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the air breather hose (A).
5.
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)

6.
Disconnect the oil temperature sensor connector (A).
7.
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

Installation
1. Installation is the reverse of removal. • ...

See also:

Interior C ( 4Door )
Front pillar trim mounting hole (Ø8.5) Front pillar trim mounting hole (Ø8) Cowl cross ...

Troubleshooting
Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) is blown Check for short and ...

Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com