Hyundai Accent Manuals

Hyundai Accent: Rocking the vehicle - Special driving conditions - Driving your vehicleHyundai Accent: Rocking the vehicle

If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth between 1st (First) and R (Reverse) in vehicles equipped with a manual transaxle or R (Reverse) and any forward gear in vehicles equipped with an automatic transaxle. Do not race the engine, and spin the wheels as little as possible. If you are still stuck after a few tries, have the vehicle pulled out by a tow vehicle to avoid engine overheating and possible damage to the transaxle.

Prolonged rocking may cause engine over-heating, transaxle damage or failure, CAUTION

Prolonged rocking may cause engine over-heating, transaxle damage or failure, and tire damage.

Do not spin the wheels, especially at speeds more than 35 mph (56 km/h). WARNING - Spinning tires

Do not spin the wheels, especially at speeds more than 35 mph (56 km/h). Spinning the wheels at high speeds when the vehicle is stationary could cause a tire to overheat which could result in tire damage that may injure bystanders.

The ESC system should be turned OFF prior to rocking the vehicle. NOTICE

The ESC system should be turned OFF prior to rocking the vehicle.

If your vehicle becomes stuck in snow, mud, sand, etc., then you may attempt WARNING

If your vehicle becomes stuck in snow, mud, sand, etc., then you may attempt to rock the vehicle free by moving it forward and backward. Do not attempt this procedure if people or objects are anywhere near the vehicle. During the rocking operation the vehicle may suddenly move forward or backward as it becomes unstuck, causing injury or damage to nearby people or objects.

Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra distance for braking. Av ...

Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be he ...

See also:

Thermostat. Components and Components Location
Components 1. Water inlet fitting 2. Thermostat 3. Heater pipe 4. Bypass hose 5. Water temp control assembly 6. Water temperature sensor 7. Gasket ...

Specifications
Specification Item Bulb Watt (W) Bulb Type Front Head lamp (High) 60 HB2 LL Head lamp (Low) ...

Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided i ...

Hyundai Accent Manuals


В© 2011-2025 Copyright www.hamanual.com