Hyundai Accent: Steering Column and Shaft. Repair procedures

Repair procedures

General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Replacement

1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

See also:

Anchor Pretensioner (APT). Description and Operation
Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

Inspection
Rotor 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the s ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...