Hyundai Accent: Troubleshooting
Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / General Information / Troubleshooting
Troubleshooting
Starting System
|
Symptom |
Suspect area |
Remedy |
|
Engine will not crank |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Transaxle range switch (Vehicle with automatic transaxle
only) |
Refer to AT group-automatic transaxle |
|
|
Fuse blown |
Replace fuse |
|
|
Starter motor faulty |
Replace |
|
|
Ignition switch faulty |
Replace |
|
|
Engine cranks slowly |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Starter motor faulty |
Replace |
|
|
Starter keeps running |
Starter motor |
Replace |
|
Ignition switch |
Replace |
|
|
Starter spins but engine will not crank |
Short in wiring |
Repair wiring |
|
Pinion gear teeth broken or starter motor |
Replace |
|
|
Ring gear teeth broken |
Replace fly wheel or torque converter |
Charging System
|
Symptom |
Suspect area |
Remedy |
|
Charging warning indicator does not light with ignition
switch "ON" and engine off. |
Fuse blown |
Check fuses |
|
Light burned out |
Replace light |
|
|
Wiring connection loose |
Tighten loose connection |
|
|
Electronic voltage regulator |
Replace voltage regulator |
|
|
Charging warning indicator does not go out with engine
running. (Battery requires frequent recharging) |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Battery cable loose, corroded or worn Alternator wiring connection loose |
Inspect cable connection, repair or replace cable |
|
|
Fuse blown |
Check fuses |
|
|
Electronic voltage regulator or alternator |
Replace voltage regulator or alternator |
|
|
Wiring |
Repair or replace wiring |
|
|
Overcharge |
Electronic voltage regulator |
Replace voltage regulator |
|
Voltage sensing wire |
Repair or replace wiring |
|
|
Discharge |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Wiring connection loose or short circuit |
Inspect wiring connection, repair or replace wiring |
|
|
Fuse blown |
Check fuses |
|
|
Electronic voltage regulator or alternator |
Replace voltage regulator or alternator |
|
|
Poor grounding |
Inspect ground or repair |
|
|
Worn battery |
Replace battery |
Specifications
Specifications
Ignition System
Items
Specification
Ignition coil
Primary resistance
0.7 В± 15 % (Ω)
Secondary r ...
Special Service Tools
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Remova ...
See also:
Curtain Airbag (CAB) Module. Components
and Components Location
Components
...
Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required.
This child seat or infant seat should be of appropriate size for the child and should
be installed in accordanc ...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com