Hyundai Accent Manuals

Hyundai Accent: Inspection - Rear Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Inspection

1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
•
In order to protect the wheel speed sensor, when measuring output voltage, a 120 Ω resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low: 0.7 V ~ 1.0 V
V_high: 1.4 V ~ 2.0 V
Frequency range: 1 ~ 2,500Hz

Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Yaw-rate and G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate senso ...

See also:

Installation
• Be sure to check the low pressure fuel hose quick-connector (A) is completely connected to ...

If engine turns over normally but does not start
1. Check fuel level. 2. With the ignition switch in the LOCK position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose. 3. If the engine sti ...

Front Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always positio ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com