Hyundai Accent: General
| 1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
| 2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
| 3. |
For measuring dimensions, both projected dimension and actual-measurement
dimension are used in this manual.
|
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
See also:
Oil Pump. Components and Components
Location
Components
1. Timing chain cover
2. Inner roter
3. Outer roter
4. Pump cover
5. Gasket
6. Oil screen
7. Oil pan
8. Drain plug gasket
9. Oil drain pl ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com