Hyundai Accent: BCM (Body Control Module)

Transmitter Code Registration (Using GDS)

1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Body Control Module (BCM). Specifications

Specifications Item Requirement Remark Rated voltage DC 12V Shall activate normally in these range. Operat ...

See also:

Installation
1. Install the washer reservoir. Before installing the pump motor, check the f ...

Immobilizer Control Unit. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash ...

Fuel Pressure Control Valve. Troubleshooting
Signal Waveform ...