Hyundai Accent: Immobilizer Control Unit. Repair
procedures
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit. Repair
procedures
Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Remove the BCM unit and the SMARTRA unit(A).
[USA]
|
| 4. |
Remove the SMARTRA unit (A) from the bracket with loosening a
shear bolt (B).
[CANADA]
|
| 5. |
Installation is the reverse of removal procedure.
|
Replacement
Problems And Replacement Parts:
Problem
Part set
GDS required?
All keys have been lost
Blank key (4)
YES
An ...
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 sc ...
See also:
Replacement
Rear Door Trim Replacement
•
Take care not to scratch the door trim and other parts.
...
Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The sys ...
Use approved window washer anti-freeze in system
To keep the water in the window washer system from freezing, add an approved
window washer anti-freeze solution in accordance with instructions on the container.
Window washer anti-freeze is avail ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com