Hyundai Accent Manuals

Hyundai Accent: Disassembly - Cylinder Head. Repair procedures - Cylinder Head Assembly - Engine Mechanical SystemHyundai Accent: Disassembly

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head. Repair procedures / Disassembly

Identify MLA(Mechanical lash adjuster), valves, valve springs as they are removed so that each item can be reinstalled in its original position.
1.
Remove the MLAs (A).
When removing MLAs, mark all the MLAs for their rearrangement.

2.
Remove the valves.
(1)
Using the SST (09222 - 3K000, 09222 - 3K100), compress the valve spring and remove the retainer lock.
(2)
Remove the spring retainer.
(3)
Remove the valve spring.
(4)
Remove the valve.
(5)
Remove the valve stem seal.
(6)
Using a magnetic pickup tool, remove the spring seat.
Do not reuse the valve stem seals.

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Inspection
Cylinder Head 1. Inspect for flatness. Using a precision straight edge and feeler gauge, measure the surface the contacting the cylinder block and the ...

See also:

Installation
1. Install the rear combination lamp assembly. 2. Connect the rear combination lamp assembly connector. 3. Conn ...

Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared for the slick pavement. Here are a few things to consider when driving in the rain: A heavy rainfall will make ...

Disassembly
Key lock assembly 1. Make a groove on the head of special bolts (A) by a punch. 2. Loosen the special bolt using a screw driver an ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com