Hyundai Accent: Description and Operation
Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Ignition System / Description and Operation
Description
Ignition timing is controlled by the electronic control ignition
timing system. The standard reference ignition timing data for the engine operating
conditions are pre-programmed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition,
etc.) are detected by the various sensors. Based on these sensor signals and
the ignition timing data, signals to interrupt the primary current are sent
to the ECM. The ignition coil is activated, and timing is controlled.
Ignition System
...
Repair procedures
On-vehicle Inspection
Spark Test
1.
Disconnect the connectors (A) and then ignition coils
(B).
2.
Disconnect ...
See also:
ESC OFF Switch. Repair
procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer ...
Installation
1.
Installation is reverse of removal.
Fuel pump plate
cover installation bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~
2 ...
Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com