Hyundai Accent: Installation
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination lamp assembly connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
...
Troubleshooting
Troubleshooting
1.
The lamp switch inputs can be checked using the GDS.
2.
To check the input value of lamp switch, select option "Body Co ...
See also:
Injector. Troubleshooting
Signal Waveform
...
Transmitter precautions
NOTICE
The transmitter will not work if any of following occur:
The ignition key is in ignition switch.
You exceed the operating distance limit (about 90 feet [30 m]).
The battery in the tra ...
Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com