Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the engine coolant temperature sensor connector (A).

3.	Supplement the engine coolant (Refer to “Cooling System” in EM group).

Inspection

1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the ther ...

Installation

• Install the component with the specified torques. • ...

See also:

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Installation
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

SRS Control Module (SRSCM). Components and Components Location
Components ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com